LE9530D PRODUCT PROFILE
Dual Channel Ringing SLIC (-145 V)
Product Status: Production
- Overview
- Technical Documents
- Tools & Software
- Applications
- Packaging & availability
- Support
- Where to Buy
| The Le9530 Dual Ringing SLIC device is a dual-channel device optimized to provide battery feed, ringing, and supervision on voice loops found in short-loop VoIP applications. This device is optimized to interface to the Broadcom BCM3378/3380/3382 and BCM6816 devices, or a similar codec. The Le9530 device operates independently from a single, user-adjusted battery and a +3.3 V VCC per channel. Each channel provides forward and reverse battery feed, voice transmission, power ringing, an ultra low-power scan state, ground start (Tip open), and a disconnect state. A test load switch is also included to support integrated test algorithms. |
Features & Benefits
- Dual Architecture
- Two fully independent integrated SLIC channel
- No impulse noise crosstalk in any operation states to the listening channel in forward or reverse active states
- Two Power Supplies
- Single user adjusted battery input per channel
- 3.3 V for VCC
- High Voltage Design
- Meets Comcast Ringing requirements without clipping
distortion - Robust solution with no damage during extended ringing cycles or switching the ringer on and off
- Allows use of 50 ? protection resistors and lower cost lower current rated protectors
- Two Grades
- Up to ?145 V ringing battery Le9530D
- Up to ?100 V ringing battery Le9530C
- Meets Comcast Ringing requirements without clipping
- Channel Independent Eight Operating States
- Scan state for minimal power dissipation
- Active Forward Battery 25mA DC Current Limit
- Active Reverse Battery 25mA DC Current Limit
- Active Forward Battery 40mA DC Current Limit
- Active Reverse Battery 40mA DC Current Limit
- Tip Open Ground Start
- Ringing
- Disconnect (Default Power Up Mode)
- Per Channel Ringing Inputs for Optimized Interface to BCM SoC Devcies
- Allows to accept driving signals from per channel voice outputs as well as from PWM outputs
- Ultra-Low On-Hook Power
- Loop Start, Ring Trip, and Ground Start Detections
- Loop closure detection with hysteresis to minimize dial pulse distortion
- Thermal Shutdown Protection with Hysteresis
- Test Load Switch
- Supports integrated test algorithms
Documentation
Design Manuals
Software Manuals
Product Previews
Specific Applications
- ZLAN-296 Applications of the ZL30320 Linux Software Porting Guide
- ZLAN-287 Applications of the ZL303xx Hybrid Clock
- ZLAN-261 Applications of the ZL303xx Bring-up Scripts
- ZLAN-252 - Perform IEEE 1588v2 PTP Testing Using the ZLE30320 Kit
- ZLAN-251 - Applications of the ZL303xx - Debug Steps
- ZLAN-267 Generating Common Frequencies with Universal Clock Translators and Universal Clock Generators
- ZLAN-286 Power Consumption and Dissipation Calculation of Clockcenter Devices
- ZLAN-269 - Universal Clock Translators/Generators Power Supply Decoupling and Layout Practices
- ZLAN-68 - List of Oscillators & Crystals that can be used with Zarlink's PLL, Digital Switches with Embedded PLL & Timing over Packet Devices
- VCP2-Type2CallerID-AppNote_Nov11.pdf
- Switching Regulator Power Supply Design Appnote
- VE880 Series Trapezoidal Ringing Appnote
- VoicePort Devices Ground Start Procedure Appnote
- ZLAN-306-Applications of ZLS3034x and ZLS30390 Application Note
- ZLAN-300-Linux Software Porting Guide Application Note
- ZLAN-265 Tracking ToD Information using the ZL30142/43
- ZLAN-212-Low_Jitter_Synchronizer_Power_Supply_Decoupling_and_Layout_Practices- Dec10.pdf
- ZLAN-301 - ClockCenter Custom OTP Configuration Service
- ZLAN-254 - Generating 156.25 MHz LVPECL and 25 MHz CMOS clocks with ZL3013X/14X/34X devices
- ZLAN-68 TOP - List of Oscillators that can be used with Zarlink's ToP Devices
Typical Applications
- Interface to Broadcom
- BCM3378/3380E Cable Modem
- BCM6816 GPON
- VoCable Modem
- VoDSL (Voice-over-DSL)
- FTTH (Fiber-to-the-Home)
- GPON
- BPON
- VoEthernet (Voice-over-Ethernet)
Product Packaging & Availability
| Part Number |
Package Type |
Pin Count |
Lead-Free Option |
Shipping Option(s) |
Lead Time(wks) |
Status |
|---|---|---|---|---|---|---|
| LE9530DETC | eTQFP | 48 | GREEN | Tray | 10-12 weeks | Production |
| LE9530DETC | eTQFP | 48 | GREEN | Tray | 10-12 weeks | Production |
| LE9530DETCT | eTQFP | 48 | GREEN | TR | 10-12 weeks | Production |
| LE9530DETCT | eTQFP | 48 | GREEN | TR | 10-12 weeks | Production |
| LE9530DPQC | QFN | 48 | GREEN | Tray | 10-12 weeks | Production |
| LE9530DPQC | QFN | 48 | GREEN | Tray | 10-12 weeks | Production |
| LE9530DPQCT | QFN | 48 | GREEN | TR | 10-12 weeks | Production |
| LE9530DPQCT | QFN | 48 | GREEN | TR | 10-12 weeks | Production |
Packaging Information
Technical Support
-
Registered users
click here
to access the service.
Not registered? Register online today and get access to all our technical support services.
Forgot your password?
Visit the page to find distributor, representative and Zarlink sales office contact information.
| Related Products | ||
| LE9530C | Dual Channel Ringing SLIC (-100 V) | |







